4-20mA Loop-Powered Isolators, 2-Wire

Models get power from the 4-20mA output or input loop (sinks or sources current). Typical uses are as a current repeater or to drive resistive loads. 651T and 250T models are ideal for applications that require an isolator with a power supply in series with the output signal. Power is obtained from the output loop. The isolator must control current draw from the power supply in the output loop which is the 4-20mA signal. Since output and power share the same two wires, this type of isolator can be placed anywhere between the field sensing device and the PLC/DCS or monitoring device. Usually, the isolator is located close to the field device. Since both the input and output signal are 4-20mA, location of the device is not critical. 670T and 270i models are useful when adding and isolating a monitoring instrument to an existing current loop. When adding a field device such as a recorder or display, no additional power source is required for the added loop or for the isolator. The isolator's output is powered by the input loop power and drives passive loads only.

Showing all 2 results

  • Compare

    651T, 652T: Multi-Channel, Two-Wire Isolators

    • DC current input
    • Single/dual-channel DC-powered isolators
    • Signal splitter
    These units receive 4-20mA process current inputs and provide isolated 4-20mA output signals. Each channel operates independently and is isolated from the others to prevent interaction between channels.
    $185$275
    Select options
  • Compare

    671T, 672T, 674T: Multi-Channel, Two-Wire Isolators

    • DC current input
    • Single, dual, or quad I/O loop-powered isolators
    These units receive 4-20mA process current inputs and provide isolated 4-20mA output signals. Power is derived from the input signal current. Each channel operates independently and is isolated from the others to prevent interaction between channels.
    $185$360
    Read more

More 4-20mA Isolators Information

651T and 250T models are ideal for applications that require an isolator with a power supply in series with the output signal. Power is obtained from the output loop. The isolator must control current draw from the power supply in the output loop which is the 4-20mA signal. Since output and power share the same two wires, this type of isolator can be placed anywhere between the field sensing device and the PLC/DCS or monitoring device. Usually, the isolator is located close to the field device. Since both the input and output signal are 4-20mA, location of the device is not critical.

670T and 270i models are useful when adding and isolating a monitoring instrument to an existing current loop. When adding a field device such as a recorder or display, no additional power source is required for the added loop or for the isolator. The isolator's output is powered by the input loop power and drives passive loads only.

Request More Information About Acromag's 4-20mA Isolator Solutions

Complete this form and an Acromag representative will contact you.

  • This field is for validation purposes and should be left unchanged.